High Precision Manual Stencil Printer

SKU
STP-350
Dispensing Needles and Tips (10)

Dispensing Needles and Tips (10)

QK440A Ionizing Air Blower

QK440A Ionizing Air Blower

Availability: In stock
$995.00

Specifications:

  •          Working area: 300x400mm, frame thickness should be less than 1.5".
  •          Max. X direction adjustment: 5/8".
  •          Max. Y direction adjustment: 5/8".
  •          Max. Z direction adjustment: 5/8".
  •          θ adjustment 10°.
  •         Open end, fit any framed stencils as long as the paste area is smaller than the base.
  •          Circuit board mount kit included, capable of two side boards.
  •          Use framed stencils. Stencil and frame not included. 
  •          Weight: 55 lb


*Squeegee not included, sold seperately.

Assembling of the Stencil Printer

1. Assembling: Unscrew one nut from each of the two long metal bars.

2. Align the two black metal bars with the two holes on the back of the 
screen printer base. Let them go through the holes. Put the nuts back 
onto the two metal bars beneath the base.

3. Adjust the position of the stencil  clapping fixture by moving the nuts
on the two vertical bars up or down. It is best to check the position with a stencil
frame.

Operation

1. Mount the stencil by tightening the clamps on the back of the stencil 
printer.

2. Align the PCB with the stencil by using the four L shaped blocks supplied.

3. Fine adjustment is achieved by turning the knobs around the base. Z direction adjustment knob is at the back.
4. Apply a thin layer of solder paste. Too much paste will cause short circuits.

More Information
upc No
length No
width No
height No